Have cleaned up my electronic desk and prepared for integration test and mass production. I still have a few components to finalise but will start doing the system testing.

Image shows the Ethernet/Can gateway, the DMX processors and a DMX control box with the properCan bus cable.

I still have to make a few cables for the test.

I also have prepared the material (boards, boxes, plugs etc) for the mass production of the network components.

First are the tank sender hubs, valve control boxes and tank processor boxes to go under the floor when I finish the tank installation. I still wait for the inspection lids from an Australian online shop. 4 weeks now and not even an answer to my email since 3 days. Last time I ordered from them, pathetic.

material plugs

I have a few boxes to make :D