0414 740 669

Monthly Archives: February 2018

Electronic Installation

By |February 3rd, 2018|BUILD, ELECTRONICS, INTERIOR BUILD|0 Comments

Over the last two weeks I also started to install some of the electronic components I had made before. The square box in the middle is the Ethernet gateway module to connect to the CAN bus.

Installed the Ethernet switch for all the Ethernet components in this cabinet and also installed the DMX controller, which is not shown in the picture. Need to take another one.

The rectangular box to the right of the gateway unit is the control unit for the 8 latching relays below the gateway unit. These latching relays control the DC circuits. The circuits are switched off […]

Bedroom

By |February 3rd, 2018|BUILD, INTERIOR BUILD|0 Comments

Again some time since the last post. I have been pretty busy with my commercial project, but still managed to do a few things on the van. Next week I will be in Sydney again for a few days, so not much time right now for the handy work.

I cleaned up the mess on the floor a bit and had to move the fridge out of it’s recess to get to the cables behind the switch board and battery panel to bundle them properly.

I also continued working in the bedroom. I built and finished the night stands in the […]